Skip to Content

Why We Make an Adapted Pedal for Each Vehicle - S13 vs 180SX Overlaid

8 October 2026 by
IEE Limited, Stefan Etter
| No comments yet

Why not just make one pedal that "fits both"?

It would be easier. Some companies do overlay multiple models, see the difference, split it down the middle and call it a day - one pedal that sort of fits both vehicles.

We don't do that.

The difference between the S13 and the 180SX pedal isn't cosmetic as you can see in the image above. It's the pedal pad position thats a fair bit different. Overlay each of our adapted pedals against the factory throttle pedal scan for its own vehicle and the pad sits exactly where Nissan put it. Run the wrong pedal and the pad sits noticeably higher than factory. You feel that every time you drive the car, and the factory pedal feel is gone.

Thats why we always scan the factory pedal and the surrounding cabin area of each vehicle, model the adapted pedal to match that geometry, and make one pedal per vehicle. Not close. Exact.

Looked at from the front/vertically, the two pedal pads overlay line up beautifully. The pads sit in essentially the same position in the car. It's only from the side that the difference shows: the height of the pedal pads relative to each other is what actually differs between these two vehicles. That's why one pedal per vehicle is the only way to do it.

Both the S13 and 180SX adapted drive-by-wire pedals are available now, each modelled specifically for its vehicle:

Our latest products

Explore our curated selection and find the products that perfectly match your needs.

Your Dynamic Snippet will be displayed here... This message is displayed because you did not provide enough options to retrieve its content.


If we don't have a Pedal Adapted to suit the vehicle you have feel free to get in touch.

IEE Limited, Stefan Etter 8 October 2026
Share this post
Sign in to leave a comment