ORDERS ONLY AVAILABLE VIA EMAIL
Please Email : Stefanetter@iee.nz
RB26 Natrually Aspirated Cable Throttle "Full Kit" Setup
What does the RB26 Natrually Aspirated Cable Throttle "Full Kit" Setup Conversion System consist of?
- 1 x Cable Mounting Bracket & Fastner Kit
- 1x CNC Machined Aluminium & Electrical Discharge Machined Shaft Connector "Front Throttle Bodies"
- 1x CNC Machined Aluminium & Electrical Discharge Machined Shaft Connector "Rear Throttle Bodies Including Cable Drive"
- 1 x Throttle Position Sensor & Mounting Bracket, Drive-Key & Fastner Kit
- 2 x TPS Plug & Terminals
- 2 x End Plates to set throttle rest position, including Grub Screws & Nuts.
- 2 x Throttle Springs 6 x Spring Guides 6 x Throttle Seals
- 1 x Dual 10mm Balance Tube Fitting
- 1 x Dual 1/8th Port Balance Tube Fitting
- Heater Tube Kit 16mm or 19mm End
- Balance Tube O-Ring Kit
Additional Items to Purchase Seperately.
Please take a look threw out range of throttle rebuild kits and balance tube fitting solutions for an easy configuration of your engine.
- This does not include a Idle control solution. Remote mounting of the idle control valve under the plenum needs to be done.
- Reference Photos Only! Desription above is what you receive.
- Custom Throttle Cable May be needed