Nissan RB26 NISMO Intake Manifold CNC Logo

This service is for Nissan RB26 NISMO intake manifold where you want to remove the unused throttle linkage bridge and cable mounting bosses for a cleaner, more simplified appearance.

The service is available for both:

• Nissan OEM RB26 intake manifolds
• NISMO RB26 intake manifolds

After these areas are removed, the manifold is carefully blended and finished to help recreate the original cast aluminium appearance.

A needle descaling process is used across the modified areas to help match the surrounding factory cast texture rather than leaving a smooth machined or heavily sanded finish.

Shave Level

Partial Shave

This option retains the factory throttle cable and linkage mounting arrangement.

For the NISMO manifold, the raised logo section is removed and blended into the surrounding manifold surface.

For the Nissan OEM manifold, there is no raised logo section, so this option is not required.

The modified areas are blended and finished to help match the surrounding cast aluminium texture.

Full Shave

This option is intended for modified throttle setups where the original cable throttle and linkage mounting features are no longer required.

On both the Nissan OEM and NISMO manifolds, the following areas are removed and blended where applicable:

• Throttle linkage bridge mounting points
• Throttle cable bracket mounting lugs

On the NISMO manifold, the raised logo section is also removed and blended.

The modified areas are then carefully finished and worked with a needle descaling tool to help recreate the original cast aluminium texture.

Surface Finish

The goal of the finishing process is to make the modified areas blend naturally into the original manifold casting.

After the unwanted features are removed, the surrounding areas are carefully sanded and blended.

A needle descaling tool is then used to recreate a cast-style texture across the modified areas.

Some minor variation in surface texture is normal because the original manifold casting itself is not perfectly uniform.

Optional CNC Machined NISMO Logo

A CNC machined NISMO logo can also be added after the shaving and finishing work has been completed.

This option is mainly intended for the NISMO intake manifold, where the original raised logo section has been shaved away.

The logo is machined directly into the aluminium surface rather than using an applied badge or plaque.

Available logo options include:

• NISMO logo
• 40th Anniversary NISMO logo

The CNC logo engraving is available as a separate add-on service available below or when adding this product to the cart.

Important Notes

• This is a permanent modification to the manifold.
• The Nissan OEM manifold does not have the raised NISMO logo section.
• The raised logo section only applies to the NISMO intake manifold.
• Full Shave removes the original throttle linkage bridge and cable throttle mounting features.
• Full Shave is intended for modified throttle arrangements where these factory mounting points are no longer required due to using ITB Drive-by-wire.
• The final cast-style finish is intended to closely match the original manifold but may not be completely identical to the surrounding factory casting.
• Please contact us before ordering if you are unsure which option is suitable for your manifold or throttle setup.