RB26 Balance Tube Press Fitting To Dual 10mm Hose Ends

This fitting is best used in the rear of the RB26 balance tube, hoses can be run directly from this fitting to the Brake & Clutch booster vac ports

These fittings are used in our RB26 ITB DBW Kits to connect back to the factory vacuum pipe which supplies the  Brake & Clutch boosters.

Two Methods can be used for installation if the fittings outside diameter tolerances don't match your balance tube hole.

- Loctite Retaining compound

- Centre punch pain the hole it is being installed in around 4 + locations to be give the fitting something to grip to, and then install with Loctite Retaining compound.

Universal Fitment Details

Dual 10mm Barb ends

Press fit end is 13.80mm ( Stainless steel )

Total height of fitting 50mm

Any configuration & placement questions feel free to contact us