ORDERS ONLY AVAILABLE VIA EMAIL
Stefanetter@iee.nz
 
Are you looking to give your OEM ITB RB26 a much needed update? Wanting better throttle response? Launch Control? Anti Lag? Cruise Control? here is what you've been waiting for all while retaining that OEM RB26 Look! 
 
What does the RB26 GTR ITB DBW Conversion System **BASIC KIT** consist of?
1 x Electric Throttle Motor Actuator Inc Shaft Support Upgrade & Pivot Lever ( Assembled )
1 x Electric Throttle Motor Actuator Mounting Bracket & Fastener Kit
2 x CNC Machined Aluminium & Electrical Discharge Machined Shaft Connectors
1 xDual Sweep Throttle Position Sensor & Mounting Bracket, Drive-Key & Fastner Kit 
1 x Adjustable Rod Linkage
1 x All mounting hardware, Grub screws, Studs, Nuts and Bolts 
 
***Important Notes***
Additional DC Motor Driver is needed for users running HALTECH 2500, Link G4+ & G4X to supply enough amps to opertate the throttle motor. if you have incorrectly installed the kit and there is too much resistance in the rotating assembly and the ECU DBW Duty is going over 100% and into a fault mode during calibration you will need to strip down and correctly re assemble the throttles and connectors, if the ECU still has an error after the assembly has been double checked then it is possible the ECU is at its limit of operating the throttle with the AMP Supply capable from the brand ECU you are using. 
Our System correctly assembled generally operates around 4-5 Amps
For Users running the Factory Twin Turbo setup you may need to address the coolant tubes running to/from the turbos to have full circulation, our heater tube does not accomadate these small hoses. as an alternative you can plumb it back into the rear block fitting where the water supply to the Oil/Water Heat exchanger use to go.
Reference Photos Only! Whats listed in the description above under "What does the RB26 GTR ITB DBW Conversion System **FULL KIT** consist of?"is what you receive. Better Photos are coming! 
ITB DBW Conversion System will not fit if your OEM Oil/Water Transfer Unit is still in place as the Electric motor comes in contact with the housing, Any other universal sandwich plates should be fine.
NO Patch Harness is supplied with the conversion kit.
This System uses 1 x Dual Sweep TPS
 
Please get familiar with the contents of Basic and Full Kit and other associated products for DBW then Email us and get in touch before placing a order so we can work through the fine detail.