Sleeved Grommet 58mm OD x 28mm ID x 4mm ↧

Our 3D Printed flexible grommets have a unique design, the split allows users to install the grommet without removing the wiring harness, simply take your new split grommet and expand it enough to place over the wiring harness first, then press the panel groove part of the grommet into the location it is being fitted to until satisfied with the fitment and orientation, the grommet features a rounded end so a cable tie can be fitted to secure the harness inside the sleeved end tightly.

The Sleeved ends of these grommets are made to have 2mm of available contraction & expansion.

Sleeved Grommet to suit

58mm ID Hole

28mm OD Wiring Harness

4mm Panel Depth

Chassis which this grommet suits

Vehicle : Nissan, S15

Grommet Location : Firewall Engine Harness