3D Printed Sleeved Wiring Grommet 18mm OD x 12.50mm ID x 1mm ↧

Sleeved Grommet to suit 18mm Panel Hole

Sleeved section 12.5mm ID

Panel Depth to suit 1mm

Chassis which this grommet suits

Model & location : BNR32 - BCNR33 - BNR34 : Throttle cable hole, after throttle cable removal when transitioning to DBW for example.

Installation Tip: Softening for Easier Fit

1. Boil hot water, or run hot water from the tap.
2. Sit the grommet inside the hot water.
3. Let it soak for one to two minutes until it softens up.
4. Try to install it straight away.