RB26 Balance Tube Press Fitting -6AN Male
This fitting is best used in the front or rear RB26 balance tube ports, AN hoses can be run directly from this fitting to the Brake & Clutch booster vac ports or any other vacuum and boost requiring components.
Two Methods can be used for installation if the fittings outside diameter tolerances don't match your balance tube hole.
- Loctite Retaining compound
- Centre punch pain the hole it is being installed in around 4 + locations to be pained and then install with Loctite Retaining compound.
Universal Fitment Specs
Aluminium
-6AN male
Press Fit Size 13.76mm OD
TL 35.60mm
Any configuration & placement questions feel free to contact us
Your Dynamic Snippet will be displayed here...
This message is displayed because youy did not provide both a filter and a template to use.