This fitting is best used in the rear of the RB26 balance tube, hoses can be run directly from this fitting to the Brake & Clutch booster vac ports
These fittings are used in our RB26 ITB DBW Kits to connect back to the factory vacuum pipe which supplies the Brake & Clutch boosters.
Two Methods can be used for installation if the fittings outside diameter tolerances don't match your balance tube hole.
- Loctite Retaining compound
- Centre punch pain the hole it is being installed in around 4 + locations to be give the fitting something to grip to, and then install with Loctite Retaining compound.
Universal Fitment Details
Dual 10mm Barb ends
Press fit end is 13.80mm ( Stainless steel )
Total height of fitting 50mm
Any configuration & placement questions feel free to contact us
