Sleeved Wiring Grommet 18mm OD x 12.50mm ID x 2.8mm ↧

No Longer available, see alternative 3D printed TPU unit.

IEE-0098 3D Printed Sleeved Wiring Grommet 18mm OD x 12.50mm ID x 1mm Depth

Sleeved Grommet to suit 18mm Panel Hole

Sleeved end has a 12.5mm ID

Chassis which this grommet suits

Model & location : BNR32 - BCNR33 - BNR34 : Throttle cable hole, after throttle cable removal when transitioning to DBW for example.

Installation Tip: Softening for Easier Fit

1. Boil hot water, or run hot water from the tap.
2. Sit the grommet inside the hot water.
3. Let it soak for one to two minutes until it softens up.
4. Try to install it straight away.